40
Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
Adjusting the Speaker Volume
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until “OFF ” appears. Turn the SET dial up to increase the
volume again.
Adjusting the Headphones Volume
The headphones terminal also serves as AV terminal. Headphones can only be used
when “ ” is displayed on the screen. If not, change the setting following the procedure
below.
1. Press the MENU button and select [VCR SETUP].
Select [AV/PHONES ], set it to [PHONES ] and
press the MENU button.
2. Turn the SET dial to increase the volume, and down
to lower the volume.
The speaker does not sound when “ ” is displayed.
Do not connect headphones unless “ ” is displayed as it produces noise.
You can also adjust the headphones volume during recording.
CAMERA
PLAY (VCR)
CARD CAMERA
CARD PLAY
CAMERA
PLAY (VCR) CARD CAMERA CARD PLAY
MENU
(70)
VCR SETUP AV/PHONES
••
AV
(phones) terminal
SET dial
Speaker
To Next Page
Loading...
Need help?
General
