1 - 4
2. LIST OF ERROR DISPLAY / INDICATION
Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected to
the printer.
2.1 Operator Call Errors (by LED Blinking in Orange)
LED
blinking in
orange
Error Solution Remarks
2 times No paper. Set the paper, and press the
Resume/Cancel button.
3 times Paper jam. Remove the jammed paper, and press
the Resume/Cancel button.
6 times The print head is not installed.
Install the print head, and close the print
head cover.
7 times The print head is not installed
properly. (EEPROM data of
the print head is faulty.)
Re-install the print head, or with the
print head installed, turn the printer off
and on.
8 times Warning: The waste ink
absorber becomes almost full
(to approx. 95% of the
maximum capacity).
Pressing the Resume/Cancel button will
exit the error, and enable printing.
In repair servicing, replace the 4-item
set of the drain pack ass’y (QL2-0194)
and the 3 ink absorbers
(QC1-1210/1211/1212) at the same
time.
The service call
error, indicating the
waste ink absorber
is full, is likely to
occur soon.
9 times The black or color ink tank is
not installed, or not installed
properly.
Install both the black and color ink
tanks. If they are installed, reseat them
properly.
If the error persists
after the ink tanks
are seated properly,
the ink tank sensor
is likely to be
faulty.
10 times Low battery Charge the battery, or connect the AC
adapter to resume printing.
2.2 Service Call Errors (by LED Blinking in Orange and Green Alternately, or Lit
in Orange)
LED
alternate blinking
in orange and
green
Error Solution
2 times Carriage error Replace the logic board ass’y
*1
, or the print unit.
4 times Purge unit error Replace the print unit.
6 times Internal temperature
error
Replace the print unit.
7 times Waste ink absorber full Replace the 4-item set of the drain pack ass’y (QL2-0194) and
the 3 ink absorbers (QC1-1210/1211/1212) at the same time
*2
.
8 times Print head temperature
rise error
Replace the print head, or the logic board ass’y
*1
.
9 times EEPROM error Replace the logic board ass’y
*1
.
Lights in orange RAM error Replace the logic board ass’y
*1
.
*1: As the waste ink counter is reset when the logic board ass’y is replaced, also replace the 4-item set of the
drain pack ass’y (QL2-0194) and the 3 ink absorbers (QC1-1210/1211/1212) at the same time.
*2: The waste ink absorber full error occurs when either the main waste ink absorber (drain pack ass’y) or the
borderless printing waste ink absorber (ink absorber) becomes full. For this reason, all the waste ink
absorbers should be replaced at the same time.
To Next Page
Loading...
Need help?
General
