Using the Full
Range of Features
56
E
Searching the Tape (Photo Search/Date Search)
Move quickly through still pictures recorded anywhere on a tape (photo search) or
between different days of recording (date search).
• You can only use this function from the Remote Controller.
1. Press down and slide the POWER switch to VCR.
• Press the SEARCH SELECT button to choose between photo/date search.
• PHOTO SEARCH or DATE SEARCH is shown in the display for a few
seconds.
2. Press the and buttons to move backwards or forwards
through the still pictures or between different days of recording.
• Press once to move to the start of the previous/next still picture or day on
the tape.
• For photo search you can press more than once to move to the
corresponding still picture (up to a maximum of 10 times), e.g. press the
button 5 times to move forward 5 still pictures.
• PHOTO-SEARCH/DATE SEARCH appears in the middle of the display
alongside the or /" or ^ mark and, for photo search, the number of
photos to search through. The recording mode is also shown (SP/LP).
Notes:
• Press the 3 (stop) side of the multi-switch to end your search.
• If you begin a search very close to the start of a recorded still picture during
photo search, the camera may skip straight past it.
• A date cannot be identified if the total recording time on that day was less than
one minute.
• Date search playback may start just before or after the beginning of the located
section.
• If the data code is not displayed correctly you will not be able to operate the date
search correctly.
• When you have set the REC ZONE for the World Clock, date search looks for
the change in date based on the adjusted time.
OFF VCR POWER
WT
2
WIRELESS CONTROLLER WL-D67
SEARCH
SELECT
To Next Page
Loading...
Need help?
General
