Mastering the Basics
8
E
Connecting the camera to an AC outlet
Use the power adapter and the DC coupler to provide your camera with instant
power from an AC outlet.
1. Slide the battery cover release switch in the direction of the arrow.
• The battery cover flips open.
2. Insert the DC coupler into the camera, in the direction of the arrow
until it clicks into place.
• Lift up and pull the small rubber stopper out slightly and feed the cable
through the opening. You can now close the battery cover.
3. Connect the DC coupler to the adapter.
4. Connect the power cable to the adapter.
5. Plug the power cable into an AC outlet.
6. Remove the DC coupler after use.
• Place the camera on its side before removing the coupler, since the coupler
may drop out when you press the battery release knob.
• Slide across the battery cover release switch (and replace the small rubber
stopper).
• Press the battery release knob (orange) upwards.
• Always turn the camera off before removing the power source.
Before operating your camera, you will need to use the power adapter to:
provide power from an AC outlet or charge battery packs
Notes:
• The power adapter converts current from a household power socket (100–240 V
AC, 50/60 Hz) to the DC current used by your camera.
• If the adapter is used next to a TV, it may cause the TV to emit noise — move
the adapter away from the TV or the antenna cable.
Powering Your Camcorder
B
A
4
1
2
3
5
6
To Next Page
Loading...
Need help?
General
