103
E
Additional
Information
Miscellaneous
Cause and/or what to do about it
• The remote sensor mode is set to
OFFB in the menu ( 44).
• The remote sensor modes of the
wireless controller and the camcorder
itself are different ( 44).
• The batteries are dead or not inserted.
• Check the screen displays ( 108).
• External interference may cause the
camcorder’s microprocessor to
malfunction temporarily. If random
letters appear in the display or if
normal operation is interrupted,
remove and then replace the power
source.
• Remove the cable and then reconnect
it or turn the power off and back on
again.
• This is not a malfunction.
Problem
? The wireless controller doesn’t
work.
? The power indicator is flashing.
? The camcorder malfunctions.
? The DV cable is connected
correctly, but there’s nothing in
the display.
? The camcorder becomes warm
during use.
• AV/PHONES is not set to AV in the
menu ( 33).
•AV\ DV OUT (Analog-digital
converter) is not set to OFF in the
menu ( 82).
• The video heads need cleaning
( 99).
• The TV/VIDEO selector on the TV
isn’t set to VIDEO ( 34-35).
• The speaker has been turned off with
the selector dial ( 32).
• Headphones are being used.
? There’s no picture on the TV
screen.
? There’s no picture on the TV
screen, even though the tape is
moving.
? There’s no sound coming from the
speaker during playback.
5_ZR40_E(92-121) 2/5/02 17:30 Page 103
To Next Page
Loading...
Need help?
General
