To Next Page

To Previous Page

30AW

6.2 GMC alarm codes

There is a LED on the GMC board that displays any board errors. The

error code can be identied from the ashing LED using the following

table. In the case of more than one error, the error with the highest

priority will be displayed until it is resolved.

In the case of normal operation, the LED ashes at a frequency of ½ Hz.

*OUIFDBTFPGBOFSSPSUIF-&%SFNBJOTPòGPSTFDPOETUIFOBUB

frequency of 1Hz, it ashes a number of times equal to the error code

BOEUIBOSFNBJOTPòBHBJOGPSTFDPOET*GUIFFSSPSDPEFIBTEJHJUT

the ashing is interrupted for 2 seconds between the rst and second

digits.

&YBNQMFFSSPS-&%PòGPSTFDPOETøBTIFTBUBGSFRVFODZPG)[

0òGPSTFDPOETøBTIFTBUBGSFRVFODZPG)[0òGPSTFDPOET

5IFDZDMFSFQFBUTVOUJMUIF-&%UVSOTPòCFDBVTFUIFQSPCMFNJT

resolved or if an error with higher priority occurs.

Diagnostic

SM_30AW.indd 74 14-03-2011 14:45:24

Carrier 30AWH004HB User Manual

Questions and Answers: