E-15
Removing
1. Make sure that the Handheld Terminal is turned off.
If the power is on, press the power key to turn it off.
2. Turn over the Handheld Terminal.
3. Remove the rechargeable battery pack cover as follows:
Slide the left and right lock switches for the rechargeable battery pack cover
simultaneously in the direction indicated by the arrows.
While holding the switches back, hook your ngertip into the notch in the
rechargeable battery pack cover and lift the cover up in the direction indicated by
the arrow.
4. Remove the battery pack by pulling up the removal tape as shown in the illustration.
Important!
When removing the battery pack, make sure you do not leave the Handheld
Terminal without a battery pack for more than about 10 minutes. Doing so can
cause data in the memory to be deleted.
When removing the battery pack, be sure you carefully follow the proper
procedure as explained in this guide.
Never try to use other type of battery than the ones that are specied for this
product.
When removing the battery pack, pull the removal tape straight up and remove
the battery pack. Removing with excessive force can damage the battery pack.
Before starting to use the DT-X100, ensure that the battery pack cover is
properly closed. If not, the power cannot be turned on or is turned off abruptly
while the DT-X100 is in use.
•
•
•
•
•
To Next Page
Loading...
Need help?
General