E-32
Other Settings
This section explains how to configure key, touch,
pedal, MIDI, and other settings.
• The basic procedure below is used for configuring
all settings. The only difference is the button that
you press to select a parameter.
• See the “Secondary Parameter Reference” on page
E-34 for details about the settings you can configure
using this procedure.
1.
Use the “Secondary Parameter Reference”
on page E-34 to find the parameter whose
setting you want to configure, and note the
applicable parameter button name.
Example: To change key, you would need to use the
TRANSPOSE button.
2.
Press the FUNCTION button.
• This will cause the button’s lamp to flash.
3.
Press the button you looked up in step 1.
• The button’s lamp will flash and the current setting of
the parameter you are configuring will appear on the
display.
Example: TRANSPOSE button
• If the button has multiple parameters assigned to it,
keep pressing the button to cycle through the
parameters until the parameter you want to configure
is displayed. See “Multiple Parameter Buttons”
below for more information.
4.
Use the T/NO and S/YES buttons to change
the setting of the displayed parameter.
Example: Lower the transpose setting by one semitone
by changing the displayed value to –01.
5.
Press the FUNCTION button to complete the
procedure.
• This will cause the button’s lamp to go out.
NOTE
• Holding down the T/NO and S/YES button will scroll
continually through the available settings.
• To return the displayed setting to its initial default value,
press the T/NO and S/YES buttons at the same time.
Multiple Parameter Buttons
The EFFECT, MIDI, and OTHERS buttons have more
than one parameter assigned to them. Use the
procedures below to select the parameter whose setting
you want to change.
EFFECT
OTHERS
MIDI
TRANSPOSE
FUNCTION
/NO
/YES
To configure other settings
PX320_e.book 32 ページ ２００７年８月１日 水曜日 午前９時２８分
To Next Page
Loading...
Need help?
General
