— 8 —
2. Test mode
Note: Do not perform the menu item unless explained here. (It may damage the internal data and
camera becomes unusable.)
2-1. Booting
To boot the test mode;
Turn the camera on while pressing SHIFT and MENU buttons.
To boot MENU1
Press SHIFT ➜ SHIFT ➜ MENU keys in order rapidly.
To boot MENU2
Press FLASH ➜ FLASH ➜ MENU keys in order rapidly.
To boot MENU3
Press SELF ➜ SELF ➜ MENU keys in order rapidly.
* To execute
Use + or – keys to select a test item then press shutter button to execute it.
2-2. Item for testing
1 TEST MODE
TEST MODE
JAP + EN
PROG
GMENU
LOADER
MOTOR
POWER
01. 03. 08. 10. 37
01. 03. 07. 10. 11
0X00000009
0X00000322
0X27
STROBE
KIZU
ZOOM
FOCUS
YES
YES
YES
YES
CCD1
CCD2
CCD3
YES
YES
YES
• TEST MODE (IRDA OK)
• PROGRAM Version
• Graphic Menu Version
• Loader Version
• Motor MCU Version
• Power MCU Version
• STROBE ADJUST (Yes/No/Ng/Err)
• KIZU ADJUST (Yes/No/Ng/Err)
• ZOOM ADJUST (Yes/No/Ng/Err)
• FOCUS ADJUST (Yes/No/Ng/Err)
• CCD ADJUST 1 (Yes/No/Ng/Err)
• CCD ADJUST 2 (Yes/No/Ng/Err)
• CCD ADJUST 3 (Yes/No/Ng/Err)
NOTE:
YES: When adjustments are completed. (Normal value)
NG: When adjustments are incompleted. (Abnormal value)
NO: IF adjustments are failed.
ERR: EEPROM Read Error
"NO" and "ERR" are designated as purple, "NG" as red.
"TEST MODE" is designated as green when adjustments are all completed.
"IRDA OK" appears beside TEST MODE TITLE when IRDA Master TEST is completed.
To Next Page
Loading...
Need help?
General
