— 28 —
5. PW-PCB Assy
5-1. VCC3, VCC3-M, VCC5, VCC7 Voltage check
1. Preparation
• AC adaptor or voltage regulator
• Multimeter
2. Adjustment procedure
• Make sure
VCC3 (CP110) = 3.3 ± 0.1 [V]
VCC3-M (CP111) = 3.4 ± 0.2 [V]
VCC5 (CP115) = 5.0 ± 0.15 [V]
VCC7 (CP950) = 8.0 [V]
3. Note
When unable to adjust using AC adaptor, use voltage regulator and supply power to be VCC1-1, 2, 3 =
5.0 ± 0.05 V.
5-2. VCC15, VEE7 Voltage check
1. Preparation
• AC adaptor or voltage regulator
• Multimeter
2. Adjustment procedure
Adjust VR100 so that VCC15 (CP118) = 15.0 ± 0.1 [V] and make sure that VEE7 (CP117) = -7.5 ± 0.2 [V].
3. Notes
When unable to adjust using AC adaptor, use voltage regulator and supply power to be VCC1-1 (CP107) =
5.0 ± 0.05 V.
5-3. BL drive voltage adjustment
1. Preparation
• AC adaptor or voltage regulator
• Multimeter
2. Adjustment procedure
Make sure that BL-VCC (CP910) is within 5.0 ± 0.05V.
3. Notes
When unable to adjust using AC adaptor, use voltage regulator and supply power to be VCC-1-1 (CP107) =
5.0 ± 0.05 V.
+ 0.6
– 0.7
To Next Page
Loading...
Need help?
General
