Casio SE-S10 Service Manual

— 29 —
TROUBLESHOOTING5.
If the following things happen5-1.
Symptom/Problem Most common causes Solutions
1 E01 appears on the display. Changing modes without
completing transaction.
Return mode switch to where it
stops buzzing and press
=
CA AMT
TEND
.
2 E08 appears on the display. Sign on operation is not
performed.
Prior to starting registration
of any other operation, press
1
~
8
and then
CLK#
%
.
3 E10 appears on the display. Printer head (platen arm) is
opened or no papaer roll.
Close the platen arm  rmly or
enter paper roll.
4 E90 appears on the display. Totals remain in the memory. Issue the general control reset
report, periodic reset report
and PLU reset report.
5 E81 appears on the display. Electronic journal memory
becomes/ is full.
Issue electronic journal reset
report.
6 No date on receipt.
Paper is not advancing
enough.
Printer is programmed as a
journal.
Program printer to print receipts.
7 Drawer opens up after ringing
up only one time.
Department is programmed
as a single item dept.
Program the dept. as a normal
dept.
8 Not clearing totals at end of
day after taking report.
Using X mode to take out
reports.
Use Z mode to take out
reports.
9 Programming is lost whenever
register is unplugged or there
is a power outage.
Bad or no batteries. Put in new batteries.
10 Register is inoperative.
Can’t get money out of
drawer.
No power. Pull lever underneath register
at rear.
In case of power failure5-2.
If the power supply to the cash register is cut by a power failure or any other reason, simply wait for
power to be restored.The details of any ongoing transaction as well as all sales data in memory are
protected by the memory backup batteries.
· Power failure during a registration
The subtotal for items registered up to the power failure is retained in memory.You will be able to
continue with the registration when power is restored.
· Power failure during printing a read/reset report
The data already printed before fhe power failure is retained in memory.You will be able to issue a
report when power is restorted.
· Power failure during printing of a receipt and the journal Printing will resume after power is restored.A
line that was being printed when the power failure occurred is printed in full.
· Other
The power failure symbol is printed and any item that was being printed when the power failure
occurred is reprinted in full.

Casio SE-S10 Specifications

General

Types of payment	Cash
Number of clerks/departments	20
Number of Price Look-Up codes (PLUs)	500 PLUs
Supported paper width	57.5 mm
Backlight	Yes
Display digits	8 digits
Display number of lines	1 lines
Dimensions (WxDxH)	330 x 360 x 203 mm
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
AC input voltage	120/230 V
Power consumption	100 mA

Weight and Dimensions

Weight	4100 g