V-R7000/V-R7100
– 16 –
mic/speaker
1
Tap “mic speaker”.
Record a voice and then play it back. Check that
the recorded voice is properly played back.
: Starts recording.
: Stops recording.
: Plays back.
After checking the playback voice, tap “Discard”
to terminate the test.
As the judgment screen is displayed, tap the
obtained test result.
NOTE: Perform the test without connecting a
Head set and the HDMI cable to the
terminal.
USB 0 (Left Side)
1
NOTE: Note that the USB numbers used in the test program and the device differ with each other.
Name in the test program Name in the device
USB 0 (Left Side) USB Storage 1
USB 1 (Back) USB Storage 2
In this manual, the notation of the USB name is base on the name used in the device.
2
Insert the USB Flash Drive to the USB Port 1.
T
ap “USB 0 (Left Side)”.
Automatic judgment is done and the test result
appears.
USB Port 1
3
NOTE: Once the test result is found “NG”, the test result will become always “NG” even if you tap
“USB 0 (Left Side)” again or perform the test again after replacing the USB Flash Drive.
In this case, unmount the USB Flash Drive once and then mount it again.
To Next Page
Loading...
Need help?
General
