61
You can use the procedures in this section to reduce the size of the projected image while maintaining
its aspect ratio and to shift the projection image vertically or horizontally, without physically moving
the projector.
To adjust the projection image size and position using Digital
Screen Shift
1.
Press the [MENU] key to display the setup menu.
2.
Use the [T] key to select “Screen Settings”, and then press the [ENTER] key.
3.
Use the [T] key to select “Digital Screen Shift”, and then press the [ENTER] key.
4.
After confirming that “Reposition Digital Screen Shift” is selected, press the
[ENTER] key.
z This displays the “Digital Screen Shift” dialog box.
5.
Use the [D-ZOOM –] and [D-ZOOM +] keys to adjust the size of the projection
image.
z You can change the zoom factor within the range of 84% to 100%.
z If a zoom factor that is less than 100% is specified, you can also perform the step 6 and 7
below to reposition the projection image. If 100% is specified, jump to step 8 of this
procedure.
6.
Use the [T] and [S] keys to shift the projection image vertically.
7.
Use the [W] and [X] keys to shift the projection image horizontally.
8.
After the image is the way you want, press the [ESC] key to close the “Digital
Screen Shift” dialog box.
9.
Press the [MENU] key to exit the setup menu.
To return the projection image size and position to their initial
defaults
1.
Perform steps 1 through 3 under “To adjust the projection image size and
position using Digital Screen Shift”.
2.
Use the [T] key to select “Restore Default Digital Screen Shift” and then press
the [ENTER] key.
3.
Press the [S] key to select “Yes”, and then press the [ENTER] key.
Digital Screen Shift
To Next Page
Loading...
Need help?
General
