75
The projector’s firmware (software in the projector flash ROM) can be updated and user logo images
can be transferred to the projector from a computer connected to the projector’s LOGO port (USB
port for ROM updating) with a USB cable.
To connect the projector’s LOGO port with a computer’s USB
port
Use a commercially available USB cable to connect the projector’s LOGO port to the computer’s USB
port.
Use a USB cable with a micro USB plug on one end for connection to the projector’s LOGO port, and
a plug on the other end with a shape that is compatible with the computer USB port.
Note
z For details about how to update the firmware and how to transfer a user logo to the projector,
see the “User Logo Transfer Guide” and the “Projector Firmware Update Guide”, which are
available at the CASIO website.
The projector can be hung from a ceiling. When doing so, the projector should be turned upside down,
and secured to the ceiling.
For full details, contact the retailer where you purchased the projector.
Important!
z When hanging the projector from a ceiling, make sure that it is at least one meter away from
fire detectors, fire alarms, and other fire protection devices. Locating the projector too close to
a fire protection device creates the risk of mis-operation of the device due to warm air
exhausted from the projector. Also, avoid locating the projector close to fluorescent lights or
other strong light sources. Bright light can shorten the operating range of the remote controller
or even make remote control impossible. When selecting a location for the projector, be sure
to test for proper operation of the remote controller.
z The vertical and horizontal orientation of the projected image is reversed from the normal
configuration when projecting from a projector hung from the ceiling. You need to change the
setup of the projector in order to correct for this. For details, see “Screen Settings 3 Ceiling
Mount” (page 57) under “Setup Menu Settings”.
Updating Firmware and Transferring a User Logo
Hanging the Projector from a Ceiling
LOGO port
To Next Page
Loading...
Need help?
General
