Casio XJ-V2 User Manual

12
To auto adjust an image (AUTO)
Press the [AUTO] key.
 Pressing the [AUTO] key automatically adjusts the frequency and phase in accordance with the
input signal, which can reduce flickering and other projected image problems.
 This operation is supported while the input source is Computer (RGB).
To change the aspect ratio of the projected image (ASPECT)
Press the [ASPECT] key to cycle through the aspect ratio settings for the projected image.
The table below shows the settings available for each type of input source.
Description of Each Setting
Note
 For details about how the aspect ratio setting affects the projected image, see “Aspect Ratio
Setting and Projection Image” (page 35).
 You can also change the aspect ratio using the Setup Menu “Screen Settings 3 Aspect
Ratio” setting (page 20).
Important!
 Note that enlarging or reducing the size of an image using the [ASPECT] key for commercial
purposes or public presentation may infringe on the legally protected copyright of the
copyright holder of the original material.
Input Source Pressing the [ASPECT] key will toggle between these settings:
RGB, HDMI (PC) Normal  Full  16:9  16:10
Component, HDMI (DTV) Normal  16:9  16:10  4:3
Normal:Projects at the projector’s maximum possible size while maintaining the input signal aspect
ratio.
Full: Projects at the projector’s maximum possible size by enlarging or reducing the input signal.
16:9: This setting specifies a 16:9 aspect ratio, which is the same as a movie screen, high-definition
TV, etc. Using this setting when the input signal is a 16:9 image that has been squeezed to a
4:3 image causes the image to be displayed with its normal 16:9 aspect ratio.
16:10: This setting specifies a 16:10 aspect ratio. Use this setting to adjust the image for projection
onto a 16:10 aspect ratio screen.
4:3: Regardless of the input signal aspect ratio, the image is always resized to an aspect ratio of
4:3 for projection.

Casio XJ-V2 Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	- m
Projection technology	DLP
Contrast ratio (typical)	20000:1
Screen size compatibility	30 - 300 \
Projector native resolution	XGA (1024x768)
Service life of light source	20000 h
Power source	AC
AC input frequency	- Hz
Power consumption (standby)	- W
Focus	Manual
Offset	72 %
Optical zoom	1.1 x
Focal length range	- mm
DVI port	No
Serial interface type	RS-232C
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	0
Noise level	37 dB
Preset modes	Presentation
Placement	Ceiling
Product type	Standard throw projector
Product color	White
Analog signal format system	-
Supported graphics resolutions	1024 x 768 (XGA), 1600 x 1200 (UXGA)
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Width	270 mm
Height	89 mm
Weight	2900 g