Introduction
01-12 79033093 D Rev.
FIG. 19: Use a piece of cardboard or wood to search for
possible leaks, never use hands.
IMPORTANT: Ensure fluids are contained during
performance of inspection, maintenance, testing,
adjusting and repair of machine. Be prepared to
collect fluid with suitable containers before
opening any compartment or disassembling any
component containing fluids. Dispose of all fluids
according to local regulations and mandates.
Do not bend or strike any high-pressure line. Do not install
bent or damaged lines.
Check lines, tubes and hoses carefully. Repair loose or
damaged lines. Tighten all connections to recommended
torque.
Replace parts if any of the following conditions are
present:
End fittings are damaged or leaking.
Outer coverings are chafed or cut.
Wires are exposed.
Outer covering is ballooning.
Flexible parts of hoses are kinked.
Outer covers have embedded armoring.
End fittings are displaced.
Batteries
FIG. 20: Electrolyte is an acid and can cause personal
injury. Do not allow electrolyte to contact skin or eyes.
Always wear protective glasses when servicing batteries.
Wash hands after touching batteries and connectors.
FIG. 21: Battery gases can explode. Keep any open
flames or sparks away from top of battery. Do not smoke
in battery charging areas.
Never check battery charge by placing a metal object
across terminal posts. Do not lay tools or other conductive
materials on battery. Use a voltmeter or a hydrometer.
Improper jumper cable connections can cause an
explosion resulting injury.
Be careful when connecting booster cables to batteries.
Electrical component damage or battery explosion can
result if booster cables are not installed correctly.
Do not charge a frozen battery as it may explode. Warm
battery to 16 degrees C (60 degrees F).
FIG. 19
FIG. 20
FIG. 21
Find manuals at http://best-manuals.com/search?&s=CHAL-79033093
To Next Page
Loading...
Need help?
General
