Introduction
01-6 79033093 D Rev.
Protective Clothing
FIG. 7: Wear a hard hat, protective glasses and other
protective equipment as required.
Mounting and Dismounting
FIG. 8: Mount and dismount machine only where there
are steps and/or handholds. Face machine whenever
mounting or dismounting.
Maintain three-point contact with steps and handrails.
Three-point contact is two feet and one hand or one foot
and two hands.
Never mount or dismount a moving machine and never
jump off machine except in an emergency.
Do not get on or off machine while moving.
Do not carry tools or supplies when mounting or
dismounting machine. Use a hand line to pull equipment
onto platform.
Do not use any controls as handholds when entering or
exiting operator compartment.
Crushing/Cutting Prevention
Stay clear of center articulation joint area of machine
when engine is running. Connect articulation joint stop
whenever servicing this area.
Support equipment properly when performing work under
equipment. Do not depend on hydraulic cylinders to hold
equipment.
m
WARNING: An implement can fall if a
control lever is moved or if a hydraulic line
breaks.
Never jump start machine by short circuiting across
starter solenoid terminals. Always start machine from
operator’s seat.
Never attempt adjustments while machine is moving or
engine is running.
When there are attachment control linkages, clearance in
linkage area changes with movement of attachment.
Stay clear of all rotating and moving parts. Keep objects
away from moving fan blades. Fan blades will throw and
cut objects.
FIG. 7
FIG. 8
Find manuals at http://best-manuals.com/search?&s=CHAL-79033093
To Next Page
Loading...
Need help?
General
