NOTICE: To comply with FCC and or Industry Canada rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
THE PROTECTOR SYSTEM
™
Installation of Optional Safety Feature
After opener has been installed and adjusted,
THE PROTECTOR SYSTEM™ accessory can be
installed. Instructions are included with this optional
device.
26
Receiver and Remote Control
Programming
Children operating or playing with a
garage door opener can injure themselves
or others.
The garage door could close
and cause serious injury or death.
Do not
allow children to operate the door control(s) or
remote control(s).
A moving garage door could injure or kill someone
under it.
Activate the opener only when you can see
the door clearly, it is free of obstructions, and is
properly adjusted.
Your garage door opener receiver and remote
control transmitter has been set at the factory to a
matching code. The door will open when the button
on the remote is pressed.
Below are instructions for programming any
additional remotes you may purchase. See available
accessories on page 27.
Your "Smart" garage door opener will operate with
up to four "Smart" remote control transmitters, a
Keyless Entry System and code switch transmitters
with red indicator lights.
To Add A Remote
1. Press and
hold
the remote push button.
(Figure 1)
2. Then press and release the "Smart" button on the
back panel of the opener (Figure 2). The opener
lights will
flash once.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener has
not learned the code.
To Change the Selected Push Button
On the Same Remote
If you purchase a multi-function remote control and
decide to use a different remote control button than
originally programmed into the opener, you need to
erase
all
the learned codes and reprogram each
remote used to operate the garage door opener.
To Erase All Remote Control Codes
• Press and hold the "Smart" button on the opener
panel until the indicator light turns off (about 6
seconds).
All
the codes the opener has learned
will be erased.
• Repeat Steps 1 and 2 for each remote control
in use.
Code programming instructions are also located
on the opener panel.
To Next Page
Loading...
Need help?
General
