Replacing the Rear Seat
Safety Belts: They’re for Everyone
To
put the seat back in, hold the seat sideways and put it This part
of
the manual tells you how to use safety belts
into the vehicle. Turn the seat to the forward position properly. It also tells you some things you should not do
and set it down, with the latches at the bottom of the seat with safety belts.
over the hooks in the floor. Pull up on the center ,release
handle and let the seat drop into place. Release the And it explains the Supplemental Inflatable Restraint
handle to let the seat latch close and make sure it locks
‘.(SIR),
or air bag system.
into place. Then, move the seatback release lever at the
right rear of the seat toward the center of the vehicle and
raise the seatback.
After returning the seatback
to
the upright position, push
the
seatback forward to make sure it is locked in place.
Then, return the outside passenger position safety belts
to the seat frame buckles,
so
they will be available for
rear seat passengers to use.
Don’t let anyone ride where he or she can’t wear
a
safety belt properly.
If
you
are in
a
crash and
you’re not wearing
a
safety belt, your injuries
can be much worse. You can hit things inside the
vehicle or be ejected from it. You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers’ belts
are fastened properly too.
1-16
To Next Page
Loading...
Need help?
General
