If you move the lever all the way up or down and
the arrow flashes at twice the normal rate, a signal
bulb may be burned out and other drivers may not see
your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check for burned-out bulbs and a blown
fuse (see “Fuses” in the Index).
Headlamp HighLow Beam Changer
To change the headlamps from low beam to high or high
to
low, pull
the
turn signal lever all
the
way toward
you.
Then release it.
When the high beams
are
on,
this light on the
instrument panel also
will be on.
Windshield Wipers
You control the windshield
wipers by turning the knob
with the wiper symbol on it.
For a single wiping cycle, turn the knob to MIST. Hold
it there until the wipers start, then let go. The wipers will
stop after
one
cycle. If you want more cycles, hold the
knob on MIST longer.
You can set the wiper speed for a long
or
short delay
between wipes. This can be very useful in light rain
or
snow. Turn the knob to choose the delay time. The
closer
to
LOW, the shorter the delay.
For steady wiping at
low
speed, turn the knob to
the
LOW
position. For high-speed wiping, turn the
knob further, to
HIGH.
To stop the wipers, move the.
knob to OFF.
2-30
-
To Next Page
Loading...
Need help?
General
