powerful lights
is
most im-
portant to assure sufficient
illuminatioo
of
the high-
way without blinding other
motorists.
To
obtain
maximum results in road
illumination and in the
safety
that
has been built
into
the
headlighting
equipment, your Chevrolet
dealer,
who
has special
equipment
for
the
pur-
pose, should be contacted
whenever light aiming
is
necessary.
PARKING
AND
TAIL
LAMPS
Combination parking and
direction signal lamps are
located at the fronl end
of
the car between the lower
front fender
and
lhe grill
(fig. 78) while combination
tail, stop and direction sig-
nal lamps
are
located in
the tail light assemblies
00
lhe
rear
fenders. Each tail lamp bulb and socket assembly
is
retained
by
a spring clip and
is
removed from
inside
the
luggage
compartment
by
pulling
the
bulb
and
socket
assembly out of the lamp body (fig. 79). Access
to
each
parking lamp
is
gained
by
removing the cover screws and
cover from outside the body.
Fig. BO-Lir.trttt Plott
Ltunp
Bulb
RnnollD/
LICENSE PLATE
LAl\fPS
Two
license plate lamps
arC
located
in
the license
plate
compartment
in
the
luggage
compartment
lid.
Access to these lamps is
gained
by
raisiog the lug-
gage compartment lid to
expose the lamp assemblies
inslaUed
[0
the
sid~of
the
license
platt:'
compartment
(fig. 80). Each lamp assem-
bly
is
retained by a spring clip and can
be
removed by
pulling
OUI
to
release clip (see inset,
fig.
80).
CIRCUIT
BREAKER
The
lighting switch controlHng instrumem panel and
eXlet-
ior lights incorporates a 30 ampere thermal circuit breaker
55
To Next Page
Loading...
Need help?
General
