500-9030v3.3
Welcome Alarm Status
Admin
Reference
31
Testing Monitored Sensors
(Performing a Walk Test)
A
Walk Test
allows you to test specific
sensors (points) in the system, to ensure that
they are functioning correctly.
A walk test can be done by users with "System Test"
authority.
A walk test must be completed within 15 minutes.
Emergency points (i.e. smoke, fire alarm, panic, etc.)
on a Monitored system display as Armed and should
not
be tested during a Walk Test. The monitoring
station must be contacted if these points are to be
tested. When tested successfully, Emergency points
will indicate PASS and Armed will change to Alarm.
"Pass" indicates that a point is functioning correctly
(i.e. the sensor is operating properly), while "Fail"
indicates that a problem may exist with that point or
that the point was not tripped.
All points except Emergency points may be
bypassed during the Review for convenience, but
arming the system with a bypass reduces system
security.
Steps:
1)
Enter your user ID
and/or PIN to log
into the keypad.
2)
Press
until
"Test" appears,
and select
Test
.
3)
Select
Area
.
4)
Now, choose one
of:
•
Test:
To test
the displayed area;
•
Next Area:
To jump to the next area.
5)
Select
Walk
to
perform a Walk
Test of this area.
At this time you are free to test the points in
the selected area (i.e. open doors, trigger
motion sensors, etc.).
The walk test must be completed within 15 minutes.
6)
After activating
points in the
tested area,
return to the keypad and select
Review
to
view the results of the Walk Test.
The tested points
and the results
(Pass/Fail) will be
displayed.
7)
Press the "
...
" key to view all points that
passed during the test. Alternatively, you
can use the
keys to display the results
of all points in the area.
8)
Select
End
when finished viewing results.
Now, you can select another area to test, or
press the (
) key a few times to log out.
Welcome
Enter ID: _
_
_
Menu Options
↓
Test
↓Time
Test?
↓
Area
↓System
AreaName.....Off
↓Test ↓Next Area
Select test type
↓
Walk
↓Holdup
Area in walk test
↓
Review
↓End
xxx
ItemName
Status ...↓
To Next Page
Loading...
Need help?
General
