Cisco 12000 - Series Chassis Modular Expansion Base User Manual

1-19
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Chapter 1 Overview: Cisco 12000 Series Router SPA Interface Processors
Cisco 12000 SIP-601 Overview
The interconnect between a SIP and a SPA can operate at either 2.5Gbps or 10Gbps. If the maximum
capacity of a SPA is greater than 2.5Gbps the interconnect operates at 10Gbps and the SPA is a "full-rate"
SPA. If the maximum capacity of a SPA is 2.5Gbps or less the interconnect operates at 2.5Gbps and the
SPA is a "quarter-rate" SPA. The Cisco 12000 SIP-601 can support up to two full-rate SPAs, or one
full-rate and three quarter-rate SPAs or four quarter-rate SPAs.
The Cisco 12000 SIP-601 face plate has one Status LED. Figure 1-18 shows the Cisco 12000 SIP-601
face plate with 2 single-width, single-height SPAs.
Figure 1-18 Cisco 12000 SIP-601 Face Plate
The Cisco 12000 SIP-601 LEDs are described in Table 1 -16 .
Cisco 12000 SIP-601 Physical Specifications
The Cisco 12000 SIP-601 physical specifications are shown in the following table.
1 SPA subslot 0 5 Ejector Levers
2 SPA subslot 1 6 Status LED
3 SPA subslot 2 7 Rate LED
4 SPA subslot 3
1
3
0
2
12000-SIP-400
158211
RATE
5 54
1 2
3 7
6
STATUS
Table 1-16 Cisco 12000 SIP-601 LEDs
LED Label Color State Meaning
Status Yellow On SIP is powered and IOS is loading.
Green On SIP is active.
Rate Off Off SIP is SIP-401 or SIP-501.
Green On SIP is SIP-601.
Table 1-17 Cisco 12000 SIP-601 Physical Specifications
Description Specifications
Physical dimensions Occupies one line card slot on a Cisco 12000 Series Router
Shipping weight 10kg
Operating temperature 32 to 104°F (0 to 40°C)

Cisco 12000 - Series Chassis Modular Expansion Base Specifications

General

Brand	Cisco
Model	12000 - Series Chassis Modular Expansion Base
Category	Network Router
Language	English