Cisco 1941W User Manual

163
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Identity Features on Layer 3 Interface
Control-Direction (Wake-on-LAN)
DETAILED STEPS
Control-Direction (Wake-on-LAN)
When the router uses IEEE 802.1X authentication with Wake-on-LAN (WoL), the router forwards traffic
to the unauthorized IEEE 802.1X ports, including the magic packets. While the port is unauthorized, the
switch continues to block ingress traffic other than EAPol packets. The host can receive packets, but
cannot send packets to other devices in the network.
Configuring Control-Direction (Wake-on-LAN)
Perform these steps to configure Control-Direction (Wake-on-LAN).
SUMMARY STEPS
1. enable
2. configure terminal
3. interface gigabitethernet slot / port
4. authentication control-direction {in|both}
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode. Enter your
password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface gigabitethernet slot/port
Example:
Router(config)# interface gigabitethernet
0/0
Enters interface configuration mode.
Step 4
authentication open
Example:
Router(config-if)# authentication open
Enables open access on a port.
Step 5
end
Example:
Router(config-if)# end
Router#
Returns to privileged EXEC mode.

Cisco 1941W Specifications

General

Brand	Cisco
Model	1941W
Category	Network Router
Language	English