Cisco ASR 907 User Manual

Powering Up the Cisco ASR 907 Router
Make certain that all card slots and compartments are closed off. Install blank faceplates on any empty slots.
Always have power supply slots filled. If you leave a power supply slot uncovered, then you risk exposure
to hazardous voltages on the power pins on the midplane.
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place. Statement 1029
Warning
After installing your Cisco ASR 907 Router and connecting cables, start the router and follow these steps:
Procedure
Step 1 Activate the DC power supply using the steps described in Activating the DC Power Supply.
Do not press any keys on the keyboard until the messages stop and the SYS PWR LED is solid
green. Any keys pressed during this time are interpreted as the first command typed when the
messages stop, which might cause the router to power off and start over. It takes a few minutes for
the messages to stop.
Caution
This is only an example of what can display. The system boots differently depending upon the
configuration that ships with your system.
Note
Step 2 Observe the initialization process. When the system boot is complete (the process takes a few seconds), the
Cisco ASR 907 Router RSP begins to initialize.
Example:
rommon 1 >
rommon 1 > boot
Located asr900rsp3-universalk9.x.x.x.-ext.bin
Image size 211681484 inode num 12, bks cnt 51681 blk size 8*512
#######################################################################################
#############################################
Boot image size = 211681484 (0xc9e00cc) bytes
Using midplane macaddr
Package header rev 0 structure detected
Calculating SHA-1 hash...done
validate_package: SHA-1 hash:
calculated 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34
expected 479a7d62:6c128ba8:3616b8da:93cb3224:5c1aeb34
Image validated
PPC/IOS XE loader version: 0.0.3
loaded at: 00800000 0D1E2004
image at: 00807673 009B8C69
initrd at: 009B9000 01006219
isord at: 01007000 0D1DF800
avail ram: 00400000 00800000
Cisco ASR 907 Router Hardware Installation Guide
148
Cisco Router Initial Configuration
Powering Up the Cisco ASR 907 Router

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English