Cisco ASR-920-24SZ-IM User Manual

Connecting a USB Flash Device 110
Removing a USB Flash Device 111
Connecting Timing Cables 111
Connecting a Cable to the BITS Interface 111
Connecting Cables to the GPS Interface 112
Connecting a Cable to the Input 10-Mhz or 1-PPS Interface 112
Connecting a Cable to the Output 10-Mhz or 1-PPS Interface 113
Connecting a Cable to the ToD Interface 113
Connecting Ethernet Cables 114
Connecting Cables to SFP Modules 115
Connector and Cable Specifications 115
CHAPTER 4 Initial Configuration 117
Checking Conditions Prior to System Startup 117
Powering Up the Router 118
Verifying the Front Panel LEDs 121
Verifying the Hardware Configuration 121
Checking Hardware and Software Compatibility 122
Configuring the Router at Startup 122
Accessing the CLI Using the Console 122
Configuring Global Parameters 124
Checking the Running Configuration Settings 125
Saving the Running Configuration to NVRAM 125
Safely Powering Off the Router 125
Automatic Shutdown of the Router 126
CHAPTER 5 Troubleshooting 127
Pinouts 127
BITS Port Pinouts 127
GPS Port Pinout 128
Time-of-Day Port Pinouts 128
Alarm Port Pinouts 129
Management Ethernet Port Pinouts 130
USB Console Port Pinouts 130
USB Flash or MEM Port Pinouts 131
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
vii
Contents

Cisco ASR-920-24SZ-IM Specifications

General

Brand	Cisco
Model	ASR-920-24SZ-IM
Category	Network Router
Language	English