Cisco Catalyst 9400 Series User Manual

Table 7: 23 Inch Rack Mount Kit Part Numbers
23-Inch Rack Mount Kit Part NumberSwitch Model
C9404-FB-23-KIT=Catalyst 9404R Switch
C9407-FB-23-KIT=Catalyst 9407R Switch
C9410-FB-23-KIT=Catalyst 9410R Switch
Table 8: 23 Inch Rack Mount Kit Contents
Parts DescriptionQuantity
Rack Mounts2
M4 Phillips pan-head screws6
12-24 x 3/4-inch Phillips binder-head screws6
Rack-Mounting the Chassis in a NEBS-Compliant Mode
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack.
Statement 1006
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of:
40°C. Statement 1047
Warning
Before you begin
Prepare for the installation as follows:
Cisco Catalyst 9400 Series Switches Hardware Installation Guide
71
Installing the Switch
Rack-Mounting the Chassis in a NEBS-Compliant Mode

Cisco Catalyst 9400 Series Specifications

General

Brand	Cisco
Model	Catalyst 9400 Series
Category	Switch
Language	English