Cisco Catalyst C9800-L User Manual

PurposeCommand or Action
Example:
Enter your password if prompted.
Note
WLC> enable
Enters global configuration mode.configure terminal
Example:
Step 2
WLC# configure terminal
Specifies or modifies the hostname for the
network server.
hostname name
Example:
Step 3
WLC(config)# hostname myWLC
(Optional) Returns to privileged EXEC mode.end
Example:
Step 4
myWLC(config)# end
Configuring the Enable and Enable Secret Passwords
To provide an additional layer of security, particularly for passwords that cross the network or are stored on
a TFTP server, you can use either the enable password command or enable secretcommand. Both commands
accomplish the same thing—they allow you to establish an encrypted password that users must enter to access
privileged EXEC (enable) mode.
We recommend that you use the enable secret command because it uses an improved encryption algorithm.
If you configure the enable secret command, it takes precedence over the enable password command; the two
commands cannot be in effect simultaneously.
Note
For more information, see the Configuring Passwords and Privileges chapter in the Cisco IOS Security
Configuration Guide. Also see the Cisco IOS Password Encryption Facts tech note and the Cisco Guide
to Harden Cisco IOS Devices tech note.
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password if prompted.
Note
Device> enable
Enters global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Specifies an additional layer of security over
the enable password command.
enable secret password
Example:
Step 3
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
39
Power Up and Initial Configuration
Configuring the Enable and Enable Secret Passwords

Cisco Catalyst C9800-L Specifications

General

Brand	Cisco
Model	Catalyst C9800-L
Category	Controller
Language	English