Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact
with such circuits, because they may cause serious injury or death. For proper installation and grounding of
the antenna, please refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code,
Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077
Warning
Hot surface. Statement 1079
Warning
Intended for installation in a restricted access location.
Warning
Related Documentation
All of the IR1101 documentation can be found online here:
https://www.cisco.com/c/en/us/support/routers/1101-industrial-integrated-services-router/model.html
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
8
Preface
Related Documentation
To Next Page
Loading...
Need help?
General
