Cisco EX Series User Manual

The Settings menu on the Touch
controller
All settings are not available on all products; therefore the menu
items shown to the right may or may not be present on your
system.
You can find a complete description of the Touch controller
menus in the user guide for your video conference system.
The Administrator Settings menu is protected with the system
password.
If needed, you can set an added restriction to users’ access
to the settings. This can be done on the web interface. Go
to Configuration > System Configuration > User Interface and
set User Preferences to Off. With this restriction, only System
Information, Call Status, Diagnostics and Restart are available
for the users.
To open the Settings menu, tap the system or user name in the
upper left corner and tap Settings.
Settings
System Information
Camera Control
Ringtone & Sound
Administrator
Call Status
Diagnostics
Language
Restart
| Administrator Sett
EMC Resilience
Reset
Call Details
Back
Pairing
IP & VLAN
Multipoint Mode
Provisioning
SIP
H323
Display
Bluetooth Headset
Background
The Settings menu
• Background: Select a background picture for your Touch controller and main video
display.
• Ringtone & Sound: Select a ring tone, the ring tone volume and key tone.
• Bluetooth Headset: Select a bluetooth headset.
• Camera Control: Set the camera parameters.
• Main Source Selection: Select the main input source, e.g. camera control.
• Display: Select brightness, color temperature and DVI mode for the main video display.
• Language: Select the language for the user interface.
• System Information: See an overview of the system configurations.
• Call Status: See an overview of the call parameters when in call, e.g. protocols,
transmit and receive rates, packet loss.
• Diagnostics: Set additional system logging on.
• Restart: Select this option to restart the system.
• Administrator: See below.
The Administrator Settings menu
• Date, Time & Location: Configure date and time settings.
• Call Details: Configure the default bit rate and auto answer settings.
• Provisioning: Start the provisioning wizard.
• Multipoint Mode: Insert the address of the Multiway server.
• IP & VLAN: Configure the IP and VLAN settings. If the Touch controller is
connected via LAN there are separate entries for the codec and the Touch.
• Network Status - Codec: Current network status for the codec.
• Network Status - Touch: Current network status for the Touch controller.
• SIP: Configure the SIP settings.
• H323: Configure the H.323 settings.
• EMC Resilience: Select this option to change the Touch controller's resil-
ience to electromagnetic noise present.
• Reset: Select this option for a complete factory reset. All your settings
are reset.
Date, Time & Location
Network Status
Main Source Selection
Cisco TelePresence Video Systems
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
34
Getting Started Guide
Contents
Introduction
User interfaces
Configuration
Appendices
Contacts
Appendices

Cisco EX Series Specifications

General

Brand	Cisco
Model	EX Series
Category	Conference System
Language	English