Cisco Firepower 4100 Series Hardware Installation Guide

Step 7
Attach the FIPS opacity shield to the cable management brackets using the four 8-32 x .375" countersink Phillips head
screws provided in the FIPS kit.
Figure 39: Attach the FIPS Opacity Shield to the Cable Management Brackets
8-32 x .375" countersink Phillips head screws (2
per side)
2FIPS opacity shield1
Cable management bracket3
Step 8
Attach the 15 TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence
Label (TEL) Placement section (section 2.13 ) in the FIPS 140-2 Non Proprietary Security Policy Level 2 Validation
document.
Step 9
Attach the power cable to the appliance and connect it to an electrical outlet.
Step 10
Press the power switch on the rear panel.
Step 11
Check the power LED on the front panel. See Front Panel LEDs, on page 7 for a description of the power LED. Solid
green indicates that the appliance is powered on.
When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.
During this time, the power LED on the front panel blinks green. Do not remove the power cable until the power
LED is completely off.
Note
Step 12
See the quick start guide for your operating software for further configuration information:
Cisco Firepower 4100 Series Hardware Installation Guide
54
Mount and Connect
Install the FIPS Opacity Shield

Cisco Firepower 4100 Series Specifications

General

Brand	Cisco
Model	Firepower 4100 Series
Category	Firewall
Language	English