Cisco Firepower 4100 Series Hardware Installation Guide

Cisco ASA for Firepower 4100 Quick Start Guide
•
•
Cisco Firepower Threat Defense for Firepower 4100 Quick Start Guide
Connect Cables, Turn on Power, and Verify Connectivity
Take note of the following warnings:
Statement 1021—SELV Circuit
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.
Warning
Statement 1051—Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments.
Warning
Statement 1053—Class 1M Laser Radiation
Class 1M laser radiation when open. Do not view directly with optical instruments.
Warning
Statement 1055—Class I and Class 1M Laser
Class I (CDRH) and Class 1M (IEC) laser products.
Warning
After rack mounting the Firepower 4100 series security appliance, follow these steps to connect cables, turn
on power, and verify connectivity.
Step 1
Connect the console port.
Using a serial console cable, connect a computer or terminal server to the RJ-45 serial console port (baud rate is 9600)
so that you can use the CLI to initially set up the Firepower 4100.
Step 2
Connect the management interface.
Install the 1 Gigabit Ethernet transceiver that was provided in the Firepower 4100 accessory kit in the Management port,
and then using an Ethernet cable, connect a management computer directly to the transceiver.
Cisco Firepower 4100 Series Hardware Installation Guide
55
Mount and Connect
Connect Cables, Turn on Power, and Verify Connectivity

Cisco Firepower 4100 Series Specifications

General

Brand	Cisco
Model	Firepower 4100 Series
Category	Firewall
Language	English