Cisco IE 2000 User Manual

33
— To remove the card, push it in until it releases for it to pop out. Place it in an antistatic bag to protect it from static
discharge.
3. After the card is installed, close the guard door and fasten the captive screw using a Phillips screwdriver to keep the
door in place.
Connecting to a Console Port
You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access the CLI:
 RJ-45 Console Port, page 33
 USB Mini-Type B Console Port, page 34
Warning: If you connect or disconnect the console cable with power applied to the switch or any device on the
network, an electrical arc can occur. This could cause an explosion in hazardous location installations. Be sure that
power is removed or the area is nonhazardous before proceeding.
Statement 1080
RJ-45 Console Port
1. Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC (see Figure 14 on page 34).
2. Connect the other end of the cable to the switch console port.
3. Start the terminal-emulation program on the PC or the terminal.
The program, frequently a PC application such as HyperTerminal or PuTTy, makes communication between the
switch and your PC or terminal possible.

Cisco IE 2000 Specifications

General

Brand	Cisco
Model	IE 2000
Category	Switch
Language	English