Cisco Linksys E4200 User Manual

Linksys E4200 Chapter 2: Advanced Configuration
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network devices, including
connection to the Internet .
Administration > Diagnostics
Diagnostics
Ping Test
Ping checks whether the IP or URL address is reachable .
IP or URL Address Enter the IP or URL address you want
to test .
Packet Size Enter the packet size you want to send . The
default is 32 bytes .
Number to Ping Enter the number of times you wish to
test the connection . The default is 5 .
Start Test To run the test, click this option . The Ping
screen shows if the test is successful . Click Close to return
to the Diagnostics screen . Click Stop to stop the test .
Diagnostics > Traceroute
Administration > Factory Defaults
The Factory Defaults screen allows you to restore the
router’s configuration to its factory default settings .
NOTE: Do not restore the factory defaults
unless you are having difficulties with the router
and have exhausted all other troubleshooting
measures . Once the router is reset, you will have
to re-enter all of your configuration settings .
Administration > Factory Defaults
Factory Defaults
Diagnostics > Ping
Restore Factory Defaults To reset the router’s settings to
the default values, click this option . Any settings you have
saved will be lost when the default values are restored .
Traceroute Test
Traceroute displays the route that packets travel between
your computer and the IP or URL address .
IP or URL Address Enter the IP or URL address you want
to test .
Start Test To run the test, click this option . The Traceroute
screen shows if the test is successful . Click Close to return
to the Diagnostics screen . Click Stop to stop the test .
Maximum Performance Wireless-N Router
43

Cisco Linksys E4200 Specifications

General

Brand	Cisco
Model	Linksys E4200
Category	Network Router
Language	English