Cisco Precision 40 User Manual

Cisco TelePresence PrecisionHD Camera
D14640.17 Cisco Telepresence PrecisionHD Camera Guide APRIL 2017 Copyright © 2017 Cisco Systems, Inc. All rights reserved. 23
Camera guide
Example:
PrecisionHD 1080p4x camera in a daisy chain
Connect to the
Camera Control socket
on the codec.
Daisy chaining PrecisionHD Camera
1080p4x
NOTE: The PrecisionHD 1080p4x can only be used as the last
camera in a daisy chain. Here depicted as the third camera.
A single daisy chain can have:
• Three cameras when using a Codec C60
• Seven cameras when using a Codec C90
Locate the extra camera and power connectors:
• Power: The first camera in the chain is powered up from
the codec by the VISCA camera control cable. Additional
cameras must use the 12V DC Power in.
• Extra camera cable: The daisy chained cameras are
connected by a VISCA Extra Camera cable (maximum
length 20 m / 65.6 ft) between the Extra Camera and
Codec Control sockets
NOTE: Only the first camera’s software is automatically
updated in a daisy chain. To update the other cameras you
have to connect them directly to the codec.
Power in
12V DC
Power in
12V DC
RJ11–RJ45
VISCA™ is a trademark of Sony Corporation
RJ11–RJ45
HDMI out:
Connect to the
Video Input 2 on
the codec
HDMI out:
Connect to the
Video Input 1 on
the codec
HDMI out:
Connect to the
Video Input 3 on
the codec
Main
camera
Second
camera
Third
camera
RJ11–RJ45
Contents
Introduction
Physical interface
Connecting the camera
Appendices
Daisy chaining
Video output format
Daisy chaining

Cisco Precision 40 Specifications

General

Brand	Cisco
Model	Precision 40
Category	IP Camera
Language	English