Place Call
Edit the Call Rate, then Place the Call
Use the down Cursor key on the remote control to move
the cursor down in order to select the More eld (
...
) and
press OK.
Once an entry has been located, press OK on the remote
control to invoke the Call menu.
In the More submenu move to Custom call (rightmost) an
press OK.
Use the horizontal Arrow keys to adjust the call rate and
press the green Call button to place the call.
Make sure Call is selected (the leftmost icon along the
bottom of the screen) and press OK on the remote
control or press the green Call button on the remote
control.
Use the horizontal Cursor keys on the remote control to
go between Favorites, Recents and Directory and then
down in one of the lists.
About Call Rate
Call rate is the term used to express
the amount of bandwidth allocated
to the call and is measured in kbps
(kilobits per second).
The higher the call rate is, the
better the quality will be, but on
the expense of higher bandwidth
consumption.
The system comes with a default
call rate. This is normally set by your
video support team.
Why would you like to temporarily
change this setting? In most cases
you will use it to avoid choking
the video call when you try to call
someone at a higher rate than their
system and connection support.
Call rate cannot be changed during
a call, but you may change it just
before you place a call, as shown
at left.
To Next Page
Loading...
Need help?
General
