Cisco UCS C480 M5 Service Manual

PCIe slot 01: Primary slot for Cisco UCS VIC
adapter card.
(Secondary slot for Cisco UCS VIC is slot 02.)
11RAID controller card for front-loading drives.
(not visible in this view; position is near chassis
floor under CPU modules)
1
Power connectors for high-power GPU cards (six)12Supercap (RAID backup) for front RAID controller
(not visible in this view; mounting bracket position
is on chassis wall under CPU modules)
2
Trusted platform module socket (TPM) on
motherboard
13Fan modules (four modules with two fans each;
hot-swappable)
3
CPU modules (up to two, font-loading)14Air diffuser for auxiliary rear drive module
This diffuser is required only when using
SAS/SATA drives in the rear drive module.
4
Left bay module (drive bays 1 - 8)
• Bays 1, 2, 7, 8 support SAS/SATA or NVMe
drives.
Front NVMe drives are not supported in a
single-CPU module system.
• Bays 3, 4, 5, 6 support SAS/SATA drives only.
An NVMe-only front drive module is
available that supports up to 8 NVMe
SSDs. You cannot mix this NVMe-only
module with SAS/SATA modules or
change module types in the field.
Note
15Position of the supercap unit (RAID backup) for
the rear RAID controller.
The clip for the supercap is on the inside surface
of the air diffuser.
5
Center bay module (drive bays 9 - 16)
• Bays 9, 10, 15, 16 support SAS/SATA or
NVMe drives.
Front NVMe drives are not supported in a
single-CPU module system.
• Bays 11, 12, 13, 14 support SAS/SATA drives
only.
16Auxiliary rear drive module; holds either (no
mixing):
• Up to eight 2.5-inch SAS/SATA drives
• Up to eight 2.5-inch NVMe SSDs
6
Cisco UCS C480 M5 Server Installation and Service Guide
6
Overview
Serviceable Component Locations

Cisco UCS C480 M5 Specifications

General

Brand	Cisco
Model	UCS C480 M5
Category	Server
Language	English