173
BRAKES
CHECKING THE BRAKE PEDAL
Do up the stoplamps switch (1) in its support (3) until it is flush with the brake pedal (4).
IMPORTANT : Do not press on the brake pedal.
"a" : shaft.
Make a quarter turn to secure the stoplamps switch (1) in place.
IMPORTANT : Do not press on the brake pedal.
NOTE : Rotational torque for refitting the stoplamps switch (1) : 0,15 m.daN maximum.
Check the gap of the stoplamps switch.
B : 1,5 to 2,5 mm.
Connect the connector of the stoplamps switch (1).
B3F2011D
B3F2012D
To Next Page
Loading...
Need help?
General
