EasyManuals Logo
Home>Coats>Wheel Balancers>XR 1750

Coats XR 1750 User Manual

Coats XR 1750
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Important:Always read and follow the on-screen operating instructions. • 31
VViiddeeoo BBaallaanncceerr
SSppeecciiffiiccaattiioonnss
Cycle Time
8 seconds (average 50 pound tire)
Maximum Outside Tire Diameter
44 inches
Maximum Tire/Wheel Weight
160 pounds (72 kg)
Wheel Diameter Range (with Offset Arm or
Manual)
10 - 24 inches
Wheel Width Range
2 - 20 inches
Balancing Display Increments
0.25 or 0.01 ounces
Resolution (Non-Round Off Mode)
0.01 ounce, position 0.70 degrees
Resolution (Round Off Mode)
0.25 ounce, position 0.70 degrees
Temperature at Balancer Location
50 degrees - 105 degrees Fahrenheit
Mounting Shaft Diameter
40 MM standard
Electrical (115 V, 1 Ph, 60 Hz)
standard 15 AMP 3-prong outlet
Australia (230 V, 1 Ph, 50 Hz)
Shipping Weight
680 pounds (308 Kg)
Net Weight with Standard Accessories
465 pounds (211 Kg)
Balancer RPM
185 - 205 RPM
FFeeaattuurreess
17 inch VGA CRT Monitor w/Tilt and Swivel
Adjustments
Automatic Data Entry for Offset, Diameter, and
Width (if equipped), - Manual Entry Backup on all
Parameters
Interactive Screens for all Modes and Functions
with Superior Graphic Displays
• Static-on-Screen™
Four Fixed Function Keys, Seven Program Keys for
user Friendly Operation
Many Balancing Modes
Dynamic (Standard): Clip-on Weights
4 Alloy: User Defined
2 PAX: User Defined
4 Static
Patch Type Weights: Static Only
Behind the Spoke Weight Placement
(All Modes with Inside Wheel Weights)
Auto Start When Hood is Lowered
Vertical Wheel Mounting System
Single Spin Balancing - Dynamic and Static
Easy-To-Read Position Indicators
Interactive Tape-A-Weight™ Placement with Offset
Arm
Cone Spring Permanently Retained in Faceplate
Hood Safety Interlock System
Extended Mounting Faceplate for Deeper Wheels
Removable Center Shaft for Closed Center Wheels
Match Mount (Optimization) Function with Weight
Optimization Program
Can be Programmed for Four Different Users
User Friendly Weight and Position Calibration
Easy Calibration of Automatic Data Entry Devices
No Bolt-down Installation
Solid State Motor Control
UL/CSA Listing

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Coats XR 1750 and is the answer not in the manual?

Coats XR 1750 Specifications

General IconGeneral
BrandCoats
ModelXR 1750
CategoryWheel Balancers
LanguageEnglish

Related product manuals