IG-NT-BB InteliGen New Technology Base Box gen-set controller (without display)
IG-NTC
InteliGen NT controller with extended communication possibilities +
switchable sensing ranges of AC voltages and currents
IG-NTC-
BB
InteliGen New Technology Base Box gen-set controller with extended
communication possibilities + switchable sensing ranges of AC voltages
and currents (without display)
IGS-NT-
LSM+PMS
Dongle for IG-XX and IS-NT to enable Load Sharing control loops and
PMS
IGS-PTM Extension module with 8 BI/BO, 4 AI and 1 AO
I-LB
Local Bridge – for direct and modem monitoring and control of multiple
gen-sets
InteliMains New Technology - Mains supervision controller; the same
controller in a different SW configuration can work as a bus-tie
IM-NT-BB
InteliMains New Technology – Mains supervision controller; (without
display)
Extension module with 8 AI.
IS-
BIN8/16
Extension module with 8 BO and 16 BI.
InteliSys New technology gen-set controller
InteliSys New technology gen-set controller
IS-NT-BB InteliSys New Technology Base Box (without display)
IS-NT-BB InteliSys New Technology Basic Box (without display)
IS-NTC-
BB
InteliSys New Technology Base Box gen-set controller with extended
communication possibilities (without display)
KWP2000 Key Word Protocol of Scania S6 unit (for engine diagnostics)
LS
Load Sharing - analog load sharing line to interconnect the gen-sets on the
site (for isolated parallel or mains parallel of multiple gen-sets); IG/IS-NT
controllers use digital Load Sharing via CAN2 bus
Option for Low Temperature modification (display equipped with heating
foil)
MGCB
Master Generator Circuit Breaker (sometimes used with multiple gen-sets
in island parallel or mains parallel operation)
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
58
To Next Page
Loading...
Need help?
General
