MINT
Multiple application with INTernal control loops - for multiple gen-sets in
island parallel or mains parallel operation; Load Sharing and VAr Sharing
controlled internally; PMS available
Mains protection relay (voltage, frequency, vector shift protections)
Occurrence Count (number of fault occurrances transmitted in diagnostic
frame from ECU)
Off load - protection type (see application manual for details)
Parameter Group Number (refer to SAE J1939-71)
PMS
Power Management System - ensures optimization of running gen-sets on
the site with multiple gen-sets; based on kW/kVA spinning reserve or on
relative (%) load; no-master system ensures high reliability
Shared (virtual) Analog INput module
SHAOUT Shared (virtual) Analog OUTput module
SHared (virtual) Binary INput module
SHBOUT SHared (virtual) Binary OUTput module
SPI
Single Parallel Island application - for single gen-sets in parallel with mains
or in island operation; suitable for CHP application; no MCB control
Single Prime Mover application - for single gen-sets without mains
Suspect Parameter Number (refer to SAE J1939-71)
Single Parallel to Mains application - for single gen-sets in parallel with
mains or in island operation, with AMF support; both MCB and GCB
SSB
Single Stand-By application - for single gen-sets with mains and break
transfer gen-set to mains
Virtual periphery I/O module – internal “SW wires” linking binary outputs to
inputs
VS
VAr Sharing - ensures VAr sharing between the gen-sets on the site via
CAN bus (for isolated parallel or mains parallel of multiple gen-sets)
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
59
To Previous Page
Loading...
Need help?
General
