INSTRUCTIONS FOR THE USER
31
4) SANITIZING
It is vital to thoroughly clean the machine at least once a week. It is
advisable to use specifically a detergent which disinfects, the use of which
will substantially increase the following advantages:
-Establishes a secure hygenic state by using active detergents and
disinfectants.
-maintains the machine in perfect hygienic conditions even during periods of
non-use.
At the end of the operation, it is necessary to run the machine empty,so as to
rinse it, for a few minutes.
5) DISENCRUSTATION
In the presence of the use of hard water, lime deposits may formulate
internally and on the dishes, which for hygienic reasons and for good care of
the machine must be removed by disencrustation.
The frequency of such procedure is according to the detergent manufacturers
advice, those products which generally contain a phosphoric acid base.
So as not to damage the machine, do not exceed doses and when the
operation is complete, rinse thoroughly.
6) LOADING AND UNLOADING OF THE MACHINE
For the transportation of the machine from the delivery point to the final
installation position, use a fork lift or adequate lifting equipment used by
authorised staff. Lift the machine by its frame, taking care that any protruding
parts are not damaged (discharges, wiring etc.).
7) MACHINE DISMANTLING
At the end of its normal lifetime, the machine has to be taken apart according
to the local regulations in force by separating the components as follows:
? ?metal parts: hood, platforms, frames, filters
? ?electrical parts: motors, remote control switches, microswitches, wiring
? ?plastic parts: racks, connections
? ?rubber parts: tubes, sleeves
8) RESINS REGENERATION OF THE WATER SOFTENER (only for
machines with built-in water softener)
The flashing of the "C.r. ." (30 sec.) on the display indicates the need to
regenerate the resins. First of all, make sure that in the designated tank
container there is some coarse salt.
This operation has to be carried out with full tank.
Close the hood and push the "S9" button for approx. 5 sec.
The display show "C. .3." (for 21' and 20"). During this operation the
machine cannot be used.
At the end of the regeneration cycle, first start the self cleaning cycle (see
page 27).
To Next Page
Loading...
Need help?
General
