HoldtoolbyInsulatedgrippingsurfaceswhenperforminganoperationwherethecuttingtoolmay
contacthiddenwiringorItscord.Contactwitha"live" wire will make exposed metal partsof the tool "live" and
shockthe operator.
Additional Rules for Safe Operation
• Know your power tool. Read operator's manual
carefully. Learn Its applications and limitations,
as well as the specific potential hazards related
to this tool. Followingthisrulewillreducetheriskof
electricshock, fire, or seriousinjury.
• Always wear safety glasses. Everyday eye-
glasses have only Impact-resistant lenses; they
are NOT safety glasses. Following this rule will
reducethe riskof seriouspersonal injury.
• Protect your lungs. Wear s face or dust mask If
the operation Is dusty. Following this rule will
reducethe riskof seriouspersonalinjury.
• Protect your hearing. Wear hearing protection
during extended periods of operation. Following
this rule will reduce the risk of serious personal
injury.
• Inspect tool cords periodically and, if dam-
aged, have repaired at your nearest Factory
Service Center or other Authorized Service
Organization. Constantly stay aware of cord
location. Followingthis rule willreducethe riskof
electricshockor fire.
• Check damaged parts. Before further use of
the tool, a guard or other part that is damaged
should be carefully checked to determine that It
will operate properly and perform its Intended
function.Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center.
Followingthis rule will reduce the riskof electric
shock,fire, or seriousinjury.
• Don't abuse cord. Never carry the tool by the
cord or yank It to disconnect Itfrom the
receptacle. Keep cord away from heat, oil, and
sharp edges. Followingthisrulewill reducethe
riskof electricshockor fire.
• Make sure your extension cord Is In good
condition. When using an extension cord, be
sure to use one heavy enough to carry the
current your product will draw. A wire gage
size (A.W.G.) of at least 16 Is recommended
for an extension cord 100 feet or less In
length. A cord exceeding 100 feet is not
recommended. If In doubt, use the next
heavier gage. The smaller the gage number,
the heavier the cord. An undersizedcord will
cause a drop in line voltage resultingin lossof
powerand overheating.
• Inspect for end remove all nails from lumber
before cutting. Followingthis rule will reduce the
riskof seriouspersonal injury.
• Drugs, alcohol, medication. Do not operate tool
while under the Influence of drugs, alcohol, or
any medication. Followingthisrule will reducethe
riskofelectricshock,fire, orseriouspersonalinjury.
• Save these Instructions. Refer to them frequently
and use them to Instruct others who may use
this tool. If you loan someone this tool, loan
them these instructions also.
4
To Next Page
Loading...
Need help?
General
