EasyManuals Logo

Craftsman 536.797480 User Manual

Craftsman 536.797480
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
i
To remove gasoline, run the engine
until the tank is empty and the engine
stops.
If you do not want to remove gasoline
a fuel stabilizer (such as Sears
Craftsman fuel stabilizer No. 33500)
may be added to any gasoline left in
the tank to minimize gum deposits
and acids. If the tank is almost empty,
mix stabilizer with fresh gasoline in a
separate container and add some to the
tank. Always follow instructions on
stabilizer container. Then run engine at
least 10 minutes after stabilizer is added
to allow mixture to reach carburetor.
Store edger/trimmer in a safe place. See
IMPORTANT under STORAGE (EN-
GINE).
Store the edger/trimmer in the wheels-
down, operating position. If the edger/
trimmer is stored in any other position, oil
from the crankcase could enter the
cylinder, causing a service problem.
You can keep your engine in good operating
condition during storage by:
Changing oil.
Lubricating the piston/cylinder area.
This can be done by first removing the
spark plug and squirting clean engine
oil into the spark plug hole. Then cover
the spark plug hole with a rag to absorb
oil spray. Next, rotate the engine by
pulling the starter two or three times.
Finally, reinstall spark plug and attach
spark plug wire.
TROUBLE CAUSE CORRECTION
Difficult starting Stale fuel Drain fuel tank. Fill with fresh
fuel
or Defective spark plug Clean and re-gap spark plug
Clogged fuel line Replace fuel filter
Engine runs
erratic Blocked fuel line or empty fuel tank Clean fuel line; check gas tank
Carburetor out of adjustment Have carburetor adjusted
Fouled spark plug Clean and adjust gap
Clogged air cleaner Tap clean or replace air cleaner
Jammed due to foreign object Clear obstruction
Cutting blade
fails to turn Loose blade Tighten blade retaining nut
Defective belt Replace V-belt
Defective quill bearings Replace the bearings
Blade fails to cut Damaged or worn blade Replace blade
properly
Excessive Loose parts Stop engine immediately; tighte_
vibration all bolts. If vibration continues,
take the unit into the nearest
Sears Service Center
15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftsman 536.797480 and is the answer not in the manual?

Craftsman 536.797480 Specifications

General IconGeneral
BrandCraftsman
Model536.797480
CategoryEdger
LanguageEnglish

Related product manuals