Your new tiller has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tiller
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utilityknife
(1) Pair ofpliers
(2) 1/2 Wrench
OPERATOR'S POSITION
When right or left hand is mentioned in
this manual, it means when you are in
the operating position (standing behind
tiller handles).
LEFT
FRONT
RIGHT
OPERATOR'S
POSITION
CONTENTS OF HARDWARE PACK
m
Rm
(1) Manual
(1) Plastic
_ Cable Clip _
(2) Lock
Washers 5/16
Q
(2) Flange Locknuts
5/16-18UNC
©
(2) Hex Nuts
5/16-18
BWMUi
(2) Hex Bolts
5/16-18 x 1-1/4
(1) Bottle Engine Oil
(2) Carriage Bolts 5/16-18 UNC x 2-3/8 Gr. 5
5
To Next Page
Loading...
Need help?
General