11-3
11. HYDRAULIC SYSTEM
Ex2900 / 3200 Operator's Manual
■ Implement Control Lever
(A) Implement control lever
These couplers are used in pairs of 1 and 2, and 3 and 4.
If, after the couplers and hydraulic lines have been
connected, the connected implement moves in a direction
opposite to an expected direction, then connect the
coupler 1 to the hydraulic line that was previously
connected to the coupler 2, and connect the coupler 2 to
the hydraulic line that was previously connected to the
coupler 1. Repeat this procedure for the couplers 3 and 4.
(1)~(4) Hydraulic quick coupler
IMPORTANT:
●NEVER connect the coupler 1 to the coupler 3, or the
coupler 2 to the coupler 4. Contact your local Cub Cadet
Yanmar dealer for technical assistance.
The implement control valve has a “float” position. When
the implement control valve is in this position, implements
such as blades or loaders, lowered to the operating
position, are allowed to follow ground contours.
Push the implement control lever forward beyond the
valve detent position to the “float” position.
IMPORTANT: Avoid damage.
●Prevent damage or contamination to the female quick
couplers. ALWAYS leave the color-coded hose ends
connected to the couplers when the couplers are not in
use.
2. Controlling the Implement Control Valve
P3013706
(A)
A2019004
(2)
Yellow
(1)
Red
(3)
Blue
(4)
Green
A3013717
3013764
To Next Page
Loading...
Need help?
General