14-4
14. PERIODIC SERVICE
Ex2900 / 3200 Operator's Manual
■ Checking the Engine Oil Level
IMPORTANT: Avoid damage.
●ALWAYS check the oil level daily. If the oil level is low, a
serious engine problem can occur.
●ALWAYS check the oil level before operation.
●ALWAYS check the oil level when the engine is cold and
not running.
●ALWAYS maintain the oil level between the lower and
the upper marks.
●ALWAYS shut the engine down and allow to cool before
adding the engine oil.
NOTE:
●Check the oil level twice a day if the engine is run longer
than 4 hours a day.
●Ensure that the engine is cold when checking the engine
oil level.
1. Park the tractor on a level surface.
2. Raise the hood.
IMPORTANT: Avoid damage.
●When the oil level is checked, dirt and dust can enter the
engine. Clean the area around the dipstick before
removing it.
3. Remove the side panel on the right side of the engine.
4. Remove the dipstick. Clean the dipstick blade with a
clean rag.
5. Reinstall the dipstick.
6. Remove the dipstick again.
7. Read the oil level on the dipstick. The oil level should
be between the lower and the upper marks on the
dipstick.
8. If the oil level is low:
(1) Remove the oil fill cap.
(2) Add the specified oil until the oil level is in the
operating range on the dipstick.
●NEVER overfill the engine with oil.
9. If the oil exceeds the upper mark level on the dipstick,
drain to a proper level.
10. Reinstall the dipstick.
11. Reinstall the side panel.
12. Lower the hood.
(A) Dipstick
(B) Oil fill cap
2. Daily Checks
NOTICE
upper
lower
A3013711
3013704
(B)
(A)
upper
lower
A3013711
To Next Page
Loading...
Need help?
General