D-Link COVR-C1210 User Manual

43D-Link COVR-C1210 User Manual
Section 3 - Conguration
DHCP Server
Status: Enable or disable the DHCP server.
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conict. Refer to Connected Clients section page 13 for how reserve
IP addresses for clients.
DHCP Lease Time: Enter the length of time for the IP address lease (in minutes).
Always Broadcast: Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100
Mbps, 1000 Mbps, or Auto (recommended).
UPnP: Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
IPv4 Multicast
Streams:
Enable to allow IPv4 multicast trac to pass through the COVR-C1210
from the Internet.
IPv6 Multicast
Streams:
Enable to allow IPv6 multicast trac to pass through the COVR-C1210
from the Internet.
Click Save when you are done.

D-Link COVR-C1210 Specifications

General

Brand	D-Link
Model	COVR-C1210
Category	Wireless Router
Language	English