DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
57
Appendix A - Technical Specifications
General
Stacking Topology: Duplex Ring, Duplex Chain
Stacking Bandwidth: Up to 80 Gbps
Stacking Units: Up to 9 switches in a stack
Stacking Costs: Up to 12 stacking costs in a stack
Backup Master Support: Yes
UTP/STP Category 3, 4, 5 for 10BASE-T
UTP/STP Category.5, 5e for 100BASE-TX
UTP/STP Category 5e for 1000BASE-T
UTP/STP Category 6a for 10GBASE-T
EIA/TIA-568 100-ohm screened twisted-pair (STP) (100 m)
Physical and Environmental
AC Input: 100~240 VAC, 50~60 Hz
Optional Redundant Power Supply
One connector in back to install optional external RPS. When internal
power fails, the optional external RPS will take over all the power supply
immediately and automatically. Supports DPS-500A or DPS-700.
Support DPS-500A: DGS-3130-30TS/30S/54TS/54S
Support DPS-700: DGS-3130-30PS/54PS
Provides a Kensington-compatible security lock, on the rear panel of the
Switch, to be able to connect to a secure immovable device. Insert the
lock into the notch and turn the key to secure the lock. The lock-and-
cable apparatus should be purchased separately
Be able to maintain the time setting when the device power is off
The IC Sensor detects the temperature on the switch automatically and
adjusts the speed
Supports a USB 2.0 Type-A flash drive with a maximum current of 1 A.
This slot only supports FAT16 and FAT32 file system architectures
DGS-3130-30TS: 30.76W (Max.), 23.20W (Standby)
DGS-3130-30S: 82.4W (Max.), 43.9W (Standby)
DGS-3130-30PS: 471.67W (Max.), 52.44W (Standby)
DGS-3130-54TS: 50.62W (Max.), 38.67W (Standby)
DGS-3130-54S: 131W (Max.), 68.7W (Standby)
DGS-3130-54PS: 487.26W (Max.), 67.96W (Standby)
To Next Page
Loading...
Need help?
General