DIR-632 Multifunction Wireless Router Supporting WiMAX,
3G GSM/CDMA with Built-in 8-port Switch
User Manual
Operation Guidelines
Connecting to Cable or DSL Modem
If you need to connect the router to a cable or DSL modem, do the following.
1. Place the router in an open location in the supposed center of your wireless network. Do not
plug the power adapter into the router.
2. Turn off your PC.
3. Unplug the Ethernet cable (that connects your PC to your modem) from your computer and
place it into the INTERNET port of your router.
4. Plug another Ethernet cable into one of the four LAN ports on the router. Plug the other end
into the Ethernet port of your PC.
5. Turn on your modem. Wait until the modem is booted (about 30 seconds).
6. Plug the power adapter to the router and connect to an electrical outlet or power strip. Wait
until the router is booted (about 30 seconds).
7. Turn on your PC.
8. Verify the LEDs of the router. The following LEDs should be on: Power, LAN (of the
relevant Ethernet port), and Internet. If not, make sure that your computer, modem, and
router are powered on and the relevant cables are connected correctly.
Page 195 of 197
To Next Page
Loading...
Need help?
Device Interface
Weight and Dimensions
